This is a Fully assembled Slayer Exciter. It acts as a high frequency solid state Tesla Coil.
This Slayer Exciter comes as pictured below with the coils Pre-Wound and the 1.5 volt Exciter Pre-Made on the breadboard. All that is needed is to connect the coils to the circuit and connect the battery.
Runs on DC from 1.5v to 4v with the circuit on the breadboard,12v or more with the other two circuits that come in this kit, Great for Camping or Emergency Lighting,Light LED's and Florescent tubes wireless as low as 1.5 Volts.
This also comes with three Slayer Exciter circuits and extra components to make all the Slayer Exciter circuit versions including the high voltage 12 volts or more Slayer Exciter.
L2 & L3 coil 9 cm X 24.5 cm with 20 cm of 30 awg magnet wire on them. 18.41 mH 3.05 uF
1=High Quality RadioShack Breadboard with the1.5v Slayer Exciter on the Breadboard
assorted test jumpers
1=9 turn pancake coil
1=5 turn pancake coil
1=L2 coil, 1=L3 coil
1=AA battery holder
1=LED With AV Plug
You must be 18 years or older to purchase this product.
If running at higher voltages this product can be a fire hazard.
This product is for educational purposes only. It is not meant to replace any conventional lighting method.
Do NOT use around any sensitive electronics, children or pets.
Please be aware and follow any FCC regulations in your area.
By purchasing this product YOU AGREE to this disclaimer AND TAKE FULL RESPONSIBILITY for any mishap that may happen when using this product this includes but is not limited to any health or property damages that may arise from using this product.
THE SELLER DOES NOT ASSUME ANY RESPONSIBILITY OR LIABILITY FOR THIS PRODUCT. THIS PRODUCT IS SOLD "AS IS" WITH NO WARRANTY OR LIABILITIES. THE BUYER ASSUMES ALL RESPONSIBILITY FOR THIS PRODUCT'S USE.
*PURCHASER AGREES TO HOLD SELLER "HARMLESS".*
Search "Slayer Exciter" on EBay for international Shipping Options.